ATTENTION:

BEFORE YOU READ THE ABSTRACT OR CHAPTER ONE OF THE PROJECT TOPIC BELOW, PLEASE READ THE INFORMATION BELOW.THANK YOU!

INFORMATION:

YOU CAN GET THE COMPLETE PROJECT OF THE TOPIC BELOW. THE FULL PROJECT COSTS N5,000 ONLY. THE FULL INFORMATION ON HOW TO PAY AND GET THE COMPLETE PROJECT IS AT THE BOTTOM OF THIS PAGE. OR YOU CAN CALL: 08068231953, 08168759420

WHATSAPP US ON  08137701720

THE EFFECT OF GOOD COMMUNICATION ON MINUTES WRITING AND PRODUCTION

(A Case Study of The Federal Polytechnic Kaura Namoda, Zamfara State)

ABSTRACT

Communication is an integral part of any organization be it business, social or political, many people can do business with one another because they understand themselves.  No any production or organizational goals can be achieved successfully without effective communication.  Communication helps to get necessary information for a successful execution of duties.  This project work will therefore try to establish how minute writing have complementary role to play in the production as far as communication is concerned.  Therefore, the data needed in writing this project was collected from Federal Polytechnic Kaura Namoda through questionnaires drafted and filled accordingly,  however certain literature and other writing materials, were also been consulted.  Finally, some recommendations to the area of the case study will be given.

TABLE OF CONTENTS

Title Page                                                                       i

Declaration                                                                     ii

Approval                                                                        iii

Dedication                                                                      iv

Acknowledgement                                                          v

Abstract                                                                         vi

Table of Contents                                                           vii

CHAPTER ONE

  1. Introduction                                                          1
    1. Statement of the Problem                                      3
    1. Purpose of the Study                                             3
    1. Significance of the Study                                      4
    1. Delimitation of the Study                                      5
    1. Limitation of the Study                                         5
    1. Historical Background                                          5
    1. Research Questions                                               9
    1. Definition of Terms                                              9

CHAPTER TWO

  • Introduction                                                                   11
    • What is Communication                                                 11

2.2.0  Types of Communications                                              13

2.2.1  Oral Communication                                                      13

2.2.2  Visual Communication                                                   13

2.2.3  Mechanical Communication                                           14

2.2.4  Telecommunication                                                        15

2.3     Communication Process                                                 15

2.4     Channel of Communication                                            16

2.5     The Causes of Ineffective Communication                      16

2.6     What is Minute                                                               17

2.6.1  Feature of Minute                                                           18

2.6.2  Taken Down Minute                                                       18

2.6.3  Kinds of Minutes                                                            19

2.7     Meeting                                                                          19

2.7.1  Types of Meeting                                                            20

2.7.2  Formal Meeting                                                              20

2.7.3  Procedure in Meeting                                                      21

CHAPTER THREE

3.1     Introduction                                                                   22

3.2     Type of Instrument used for Data Collection                   22

3.2.1  Primary Sources of Collecting Data                                 22

3.2.2  Questionnaire                                                                 23

3.2.3  Interview                                                                        23

3.2.4  Observation                                                                    24

3.3     Population of the Study                                                  24

3.4     Sample of the Study                                                       24

3.5     Method of Data Analysis                                                 24

CHAPTER FOUR

4.1     Introduction                                                                   26

4.2     Data Presentation and Interpretation                                26

4.3     Findings                                                                         37

CHAPTER FIVE

5.1     Summary                                                                       36

5.2     Conclusion                                                                     37

5.3     Recommendations                                                          38

          References                                                                      40

          Appendixes                                                                    41     

CHAPTER ONE

INTRODUCTION

1.1     INTRODUCTION

          Production transact business through communication to both within and outside their area of operation.  The business transacted can be relevant to their set objectives in one-way or the other there is no doubt that such business transaction need to be coordinated for future references and smooth running of the production such coordination can not be possible without coming together of good management or appointed representation of the said production to discuss approved procedures that will pursued the successful conduct of the affairs of that production.  In fact that is where meeting becomes necessary, during which all the affairs transpired need to be recorded i.e minute are kept for future references.

          As one of the most important futuristic document to every organization with particular concern to Polytechnic minute writing become interested to the researcher.

          Omotosho (1987) define communication as the “process by which information passed between individual or organization by means of previously agreed method (either verbal or writing):.

Webster Merriam (1987) define minute as ‘a written record of the business transacted of a meeting”.

Sharman (1978) defined communication as “the tread that links all members of group.  It is the force which keep an organization together, it also makes living together possible”.

According to Hall (1976) communication is “the act of any natural or artificial means of conveying information or giving instructions”.

According to Chuden (1978) says communication as the “process of transmitting or passing a message ideas and information in order to influence human behaviour of the receiver”.

Lukman (2006) define  communication as “a message that is send to some one for example, making telephone calls, or by sending a letter or a fax”.

Tahir (1988) defined communication as “the process for signs in such a way as to help a receiver (audience) perceives a meaning or understanding similar to that in the mind of the communicator (sender)”.

1.2     STATEMENT OF THE PROBLEMS

          Minute writers preparing to take down minute of meetings, the point to remember the exercise of your skill in sorting out the opinion, discussion and occasional “red hearings” from the real decision reached if there is voting the number of votes are counted, there must be shown, it was observed that in almost all production confidential secretary or minute writer’s are not appointed or assigned to perform others duties to typing only.  All production causes some of the minute writers to be ineffective.

1.3     PURPOSE OF THE STUDY

          The purpose of this project is to find out the role of confidential secretaries, before, during and after the meeting.

          The objectives behind this research are as follows

  1. To study the methods available in writing down minute of meeting
  2. To map out strategies for effective and accurate method of taking down minutes of meeting
  3. To find out causes and factors that militates against the effective utilization of confidential secretaries during meeting.
  4. To find out problems encountered while taking down minutes of meeting etc.

1.4     SIGNIFICANCE OF THE STUDY

          The research will help the federal polytechnic Kaura Namoda to improve the ability of their secretaries in minute writing

          The researcher will also create awareness to other secretarial staff of their importance in taking down minutes of meeting as well as the necessary procedures and skill in minute writing

          The study will also serve as a means of educating other researchers who are willing to take up topic in communication similar to this one.

1.5     DELIMITATION

          The research finding was affected by the following reasons:

  1. In sufficient research materials such as paper presentation, books, magazine, journals and seminars.
  2. Lack of sufficient funds at the disposal of the researcher
  3. The people’s habit especially when they asked question by a researcher, they refused to give a reliable answer to questions for the reason best know to them.

1.6     LIMITATION

          This study has a very limited scope.  It focuses only on the effect of good communication vis – a – vis in the Federal Polytechnic Kaura Namoda only.

1.7     HISTORICAL BACKGROUND OF THE CASE STUDY

          The Federal Polytechnic, Kaura Namoda, Zamfara State was formulated, established by the then Executive President of Nigeria Alhaji Shehu Shagari in June 1983 vide a decree no 33 of 25 July 1979 as amended in 1985 with others.  The Polytechnic is situated in Kaura Namoda Local Government that covers an area of 4.98 square kilometers and has a population of 370,367 according to 1991 Population Census figures, among the pioneer local government that was created in 1967.  The objective of the polytechnic is specified in the decree as follows; to provide full time or part time courses as instruction and training in:

  1. Technology; applied science, commerce and management
  2. And in such other fields or approved learning relevant to the need of the development in Nigeria in the areas of individual and agricultural production and distribution.
  3. And for research on the development of adaptation which may from time to time be determined.
  4. To arrange conference, seminars and the study group relevant to the field of learning.

The polytechnic has two campuses know as “ACADA” which is situated at the northwest of the town, while the “MAIN CAMPUS” is situated along Shinkafi Road, some three kilometers away from the town campus, the polytechnic currently has five schools and these schools are headed by directors.

To perform such other function as opinion of the Council may serve to promote the objective of the polytechnic.  The Rector was in charge of the polytechnic.  The first Rector of the Federal Polytechnic Kaura Namoda was in person of Alhaji Ja’afar B. Ango (1983 – 1991) Engr. Lugard A. Ahmed is the present Acting Rector of the Polytechnic.  The Federal Polytechnic Kaura Namoda comprises of five school namely:

  1. The School of Science and Technology comprises of the department of Science Laboratory Technology, Catering and Hotel Management Food Science Technology, Maths and Statistics and Computer Science.
  2. School of Environmental Studies comprises of Architectural Technology, Quantity Survey and department of Building Technology
  3. School of Business and Management Studies it has department of Business Studies, Office Technology and Management, Accountancy, Banking and Finance, Marketing and Public Administration.
  4. School of Engineering Technology; comprises of Electrical/Electronic Technology, Civil Engineering and Mechanical Engineering Technology.
  5. School of General Studies; comprises of department of Pre-ND BAM, Science and OTM.

The Polytechnic also runs a Consultancy Unit which is headed by a director and it runs part-times programmes such as certificate courses in Public Account and Audit, Public Administration, Electrical/Electronic Engineering, Computer Science and OTM, while the diploma course in Public Administration, Public Account and Audit, Computer Studies and Islamic Studies respectively.

1.8     RESEARCH QUESTION

          In any project or research of this nature a researcher must raise certain issue and ask certain question viz:

  1. How does the secretary’s position in a production affect his competence in writing minute?
  2. What are the reason for not giving confidential secretaries opportunity to take minute of meeting?
  3. What are other duties to be performed by confidential secretary apart from typing?
  4. To what extent is taking minute of meeting included in the schedule of confidential secretary?

1.9     DEFINITIONS OF THE TERMS

1.       Communication:  is the process of sending understandable message and receiving understandable feedback.

2.       Minute:  is the formal record (short and concise proceeding of what was discussed at the meeting).

3.       Meeting:  refers to an assemble of people for a particular purpose, especial for formal discussion.

4.       Secretary:  A person who employed in an office or who has mastering of the secretarial skill, usually working for another person dealing with filling, typing, letters, answering telephone calls, receiving visitors, writing minute of the meeting.

5.       Production:  Is the part of productive process as those engaged in manufacturing enterprises.

6.       Orgnisation:  The organized group of people or institution

7.       Achievement:  Producing the intended result.

HOW TO RECEIVE PROJECT MATERIAL(S)

After paying the appropriate amount (#5,000) into our bank Account below, send the following information to

08068231953 or 08168759420

(1)    Your project topics

(2)     Email Address

(3)     Payment Name

(4)    Teller Number

We will send your material(s) after we receive bank alert

BANK ACCOUNTS

Account Name: AMUTAH DANIEL CHUKWUDI

Account Number: 0046579864

Bank: GTBank.

OR

Account Name: AMUTAH DANIEL CHUKWUDI

Account Number: 3139283609

Bank: FIRST BANK

FOR MORE INFORMATION, CALL:

08068231953 or 08168759420

AFFILIATE LINKS:

myeasyproject.com.ng

easyprojectmaterials.com

easyprojectmaterials.net.ng

easyprojectsmaterials.net.ng

easyprojectsmaterial.net.ng

easyprojectmaterial.net.ng

projectmaterials.com.ng

googleprojectsng.blogspot.com

myprojectsng.blogspot.com.ng

https://projectmaterialsng.blogspot.com.ng/
https://foreasyprojectmaterials.blogspot.com.ng/
https://mypostumes.blogspot.com.ng/
https://myeasymaterials.blogspot.com.ng/
https://eazyprojectsmaterial.blogspot.com.ng/
https://easzprojectmaterial.blogspot.com.ng/

By admin

Leave a Reply

Your email address will not be published. Required fields are marked *